CA-2103 GSM/GPS car alarm

GSM/GPS car alarm with support for installation in vehicles with a CAN bus. Besides protection of car entries such as the doors, boot and hood you can extend the installation with up to 24 wireless detectors of the JA-100 and JA-18x series.

GSM/GPS car alarm

CA-2103 GSM/GPS car alarm

The car alarm offers partial and full arming and can be controlled by Jablotron remote controls, the original remote controls of the car or both systems. The car alarm offers a Geofence function - information about leaving a defined zone and a departure report (both using SMS). For this product MyJABLOTRON offers the drivers' logbook function with the possibility of identification of up to 99 drivers and a service for displaying the system status and the possibility of its control. The car alarm supports remote FW upgrades.

Technical specifications

power supply 12/24 V DC (8 – 32 V)
midle current consumption max. 20 mA
peak consumption (during communication) 1 A
working range of the GSM module E-GSM/GPRS 850 / 900 / 1800 / 1900MHz
max. output power of the transmitter 2 W for GSM 850/900
1 W for GSM 1800/1900
remote control receiver frequency 868.1 MHz, GFSK, e.r.p. <25 mW
operating temperature range -20 °C to +85 °C
SIR output switching the supply voltage, max. load 1.3 A
immobilization circuit 8 A permanently, up to 12 A in the short term
output signals for control of the central locks max. 200 mA, switching to GND
length of impulses for the central locks 0.5 s or 4 s or possibly 60 s (selectable)
comply with regulation ECE No.116
safety EN 62368-1
EMC ECE No. 116, ČSN ETSI EN 301 489-1, -3, -7
radio spectrum ETSI EN 301 511, ČSN ETSI EN 300 220-2
can be operated according to ERC/DEC98(20,21), ECC/DEC/(04)06, ERC/DEC/(97)02, ECC/DEC/(06)01, VO-R/10 (ERC/REC 70-03)

Related products

JA-185P Wireless ceiling PIR detector

The JA-185P is a small-size wireless PIR sensor suitable for protecting small rooms or car interiors. It is designed for wall or ceiling installations.

JA-185B Wireless ceiling glass-break detector

A small-size glass-break sensor that detects window breaking. It is designed for building interior installations. It uses the analysis of air pressure variations combined with the characteristic sound of glass-breaking.

JA-150ST Wireless fire and temperature detector

The JA-150ST optical wireless smoke and temperature detector detects fire inside residential or commercial premises. It allows these settings: smoke and heat, smoke or heat, smoke only, heat only.

JA-151ST Wireless combined smoke and heat detector with built-in siren

It is used to detect fire hazards in the interior of residential or commercial buildings. The detector can be installed in mobile homes or caravans. The product is not designed to be installed in industrial premises.

JA-151ST-A Wireless combined smoke and heat detector with built-in siren

Used to detect a fire risk in the interior of residential or commercial buildings. It comprises a siren that indicates a fire alarm both from the entire detector and from another fire detector in the system.

BB-03 Spare battery for CA-2103, CU-08A

Spare battery for CA-2103 a CU-08A.

MCB-03 Innovated CAN bus converter

This product replaces the older MCB-02 module. It supports reading data from CAN buses, newly also FD CAN and LIN bus. The module converts digital information to analogue form, in order to connect to the inputs of the CA-2103, CA-345 and other car alarms. It switches information on vehicle locked/unlocked status, ignition status, door open and close, hood open and close, etc.

MCO-04 Car alarms output module

The product is an extension module for CA-2103 and CA-345 series car alarms for controlling appliances in the vehicle - independent heating, power supply for additional detectors, control of optical signalling and other functions.