JA-111H TRB Bus module interface for wire detector

The JA-111H TRB module is designed for the connection of any wired detector (with contact or impulse outputs) to the JABLOTRON 100+ system and provides it with a power supply.

Bus module interface for wire detector

JA-111H TRB Bus module interface for wire detector

This built-in module can be directly integrated into the detector.

  • One input of the module has a fixed Tamper signal, the second input reports an alarm signal and the third input is used to report a fault of a connected device or to report a special “Masking” signal (for detectors with an Anti-masking function).
  • The module can also be used for the connection of a CT-01 roller blind detector.
  • The module can be used to control programmable PG outputs.
  • It supports setting of a minimum activation time for alarm triggering (0.1 s - 300 s).
  • The detector features status as well as impulse activation.
  • The module is a device of the JABLOTRON 100+ system, is addressable and occupies one position in the system.

Technical specifications

Power from control panel BUS 12 V DC (9…15 V)
Current consumption - Nominal consumption - to calculate backup 8 mA
all inputs connected to GND
(+ consumption of connected devices)
Current consumption - Maximal consumption - for cable selection 12 mA
(+ consumption of connected devices)
Maximum allowed current of the connected detector 50 mA
Dimensions 16 x 30 x 12 mm
Weight 8 g
Classification Security grade 2/environmental class II
Note: valid only, if it is built-in to security grade 2 or higher certified housing
- according to EN 50131-1, EN 50131-3 (ACE type B)
- environmental Indoor general
- operating temperature range -10 to +40 °C
- average humidity 75 % RH non condensing
- certification body Trezor Test s.r.o. (no. 3025)
Valid for installation of the module into a product certified for security grade 2/environmental class II and also if the connection to the module is compatible.
Also complies with EN 50130-4, EN 55022

Similar products

JA-110M Bus module for magnetic detectors - 2 inputs

The JA-110M bus module is used to connect wired magnetic door/window detectors to the bus and contains two independent inputs programmable to be NC/NO or using a balancing resistor.

JA-118M BUS module for magnetic detectors - 8 inputs

The module provides 8 inputs designed especially for connecting magnetic detectors. Installation into a JA-190PL universal multipurpose box is recommended (or into a KU-68 wall –mounted universal box).

JA-116H BUS expander – 16 inputs

Bus expander is used for powering and connecting up to 16 detectors with contact outputs. It is possible to install the module straight into the JA-106K control panel.