JA-120N Bus module for control of an electric lock

The JA-120N module is designed for the power supply and control of electric locks and release systems from the system bus. It is fitted with batteries that ensure the initial current impulse required to open el. locks.

Bus module for control of an electric lock

JA-120N Bus module for control of an electric lock

The JA-120N can be conveniently installed in all places where an external power supply for electric lock control would be difficult to install. To module responds to a PG output of the control panel or it can be activated with a button connected to the IN input (it can be optionally locked by section control). The module is addressable and it occupies one position in the system

Technical specifications

Power from the control panel BUS (9 … 14 V)
3x NiMh rechargable accumulator type AA Eneloop 1900 mAh
Please note: Batteries are not included
External power +12 V
Current consumption in standby mode 10 mA
Current consumption for cable choice 60 mA
DOOR output load (Eneloop batteries)
Pulse (1s) 600 mA
Continuous 300 mA
Dimensions 90 x 90 x 35 mm
Weight 185 g
Operationa temperature range -10 °C - +40 °C
Classification Grade 2 according to EN 50131-1, EN 50131-3,
Operational environment according to EN 50131-1 II. General indoor
Also complies with EN 50130-4, EN 55022

Similar products

JA-111N Bus signal output module PG

The JA-111N power output module PG offers a switching relay (2 A/60V DC) with NO or NC modes . The corresponding PG output copied is set by DIP switch (one of the PG outputs PG 1 - 32).

Related products