Jablotron

JA-150TP Wireless indoor thermostat

Designed to measure and control the indoor temperature. The thermostat expands the application range of the JABLOTRON 100 system in the domain of home automation with simple zone control.

Wireless indoor thermostat

JA-150TP Wireless indoor thermostat

For switching the heating, standard control panel programmable outputs are used.

In a building, up to 4 thermostats can be installed that can control up to 4 independent circuits. The product is a component of the JABLOTRON 100 system, is addressable and occupies one position in the system.

  • Full integration in MyJABLOTRON = information on the current status and remote control of the thermostat
  • Automatic switch-over to the economy temperature on setting the premises
  • Weekly schedule mode
  • Possibility to enter the manual temperature setting mode
  • Possibility to switch off if only a minimum temperature should be maintained in the building
  • Heating suppression if a window is open
  • Report in the case of overheating or freezing
  • Easy control by dial
  • Temperature history graph

Specifications

Power supply 2 AA alkaline batteries (LR6) 1.5 V 2400 mAh
Warning: Batteries are not included in the product package.
Typical service life 2 years
Communication band 868.1 MHz, JABLOTRON protocol
Communication range approx. 300 m (free terrain)
Recommended installation height 1.5 m above floor level
Operating temperature range -10 to +70 °C
Measurement accuracy in the range of operating temperatures 0.1 °C
It also meets the requirements of EN 50130-4, EN 55022
Dimensions 66 x 90 x 22 mm

Related products

LD-81 The LD-81 flood detector

The detector indicates room water floods (e.g. cellars, bathrooms). This information is sent to an alarm system for alert message transmission. It is connectible to an Oasis alarm system via a JA-81M wireless detector.

JA-180G Wireless gas leak detector

The JA-180G detector is used to indicate leaking of explosive gases (natural gas, methan, propane, butane). The detector detects two levels of gas concen-tration - different output reactions.

JA-110ST Bus combined smoke and temperature detector

The JA-110ST bus fire detector (optical and temperature detection) detects fire in residential and commercial buildings . Allows you to set detection: optical and thermal, optical or thermal, optical only or temperature only.

JA-150ST Wireless fire and temperature detector

The JA-150ST optical wireless smoke and temperature detector detects fire inside residential or commercial premises. It allows these settings: smoke and heat, smoke or heat, smoke only, heat only.

JA-110F Bus flood detector

The detector is used to indicate flooding (in basements, bathrooms, etc.). This information is transmitted to the alarm system bus.

JA-110TP Bus indoor thermostat

In a building, up to 4 thermostats can be installed that can control up to 4 independent circuits. The product is a component of the JABLOTRON 100 system, is addressable and occupies one position in the system.

JA-111TH Bus temperature detector

It supports heating control by means of a control panel programmable output based on the measured temperature. All the functions are set in MyJABLOTRON, allowing the user to monitor and control everything anytime anywhere.

JA-151TH Wireless temperature detector

It supports heating control by means of a control panel programmable output based on the measured temperature. All the functions are set in MyJABLOTRON, allowing the user to monitor and control everything anytime anywhere.