Jablotron

JA-110G-CO Bus module for connection of an Ei208W(D) CO detector

This is a plug-in module designed for direct installation in a stand-alone Ei208W or Ei208DW CO detector, which enables its bus connection to the JABLOTRON 100 system.

Bus module for connection of an Ei208W(D) CO detector

JA-110G-CO Bus module for connection of an Ei208W(D) CO detector

It transmits information about an alarm, detector activation and detector battery status to the system. It occupies one position in the system.

Specifications

Power supply via the control panel bus 12 V (9 - 15 V)
Current consumption (idle/peak) 5 mA/5 mA
Dimensions 48 x 19 x 14 mm
Environment according to EN 50131-1 II. indoor, general
Operating temperature range -10 °C to +40 °C
In conformity with EN 50130-4, EN 55022, EN 50581

Related products

LD-81 The LD-81 flood detector

The detector indicates room water floods (e.g. cellars, bathrooms). This information is sent to an alarm system for alert message transmission. It is connectible to an Oasis alarm system via a JA-81M wireless detector.

JA-180G Wireless gas leak detector

The JA-180G detector is used to indicate leaking of explosive gases (natural gas, methan, propane, butane). The detector detects two levels of gas concen-tration - different output reactions.

JA-110ST Bus combined smoke and temperature detector

The JA-110ST bus fire detector (optical and temperature detection) detects fire in residential and commercial buildings . Allows you to set detection: optical and thermal, optical or thermal, optical only or temperature only.

JA-150ST Wireless fire and temperature detector

The JA-150ST optical wireless smoke and temperature detector detects fire inside residential or commercial premises. It allows these settings: smoke and heat, smoke or heat, smoke only, heat only.

JA-110F Bus flood detector

The detector is used to indicate flooding (in basements, bathrooms, etc.). This information is transmitted to the alarm system bus.

JA-110TP Bus indoor thermostat

In a building, up to 4 thermostats can be installed that can control up to 4 independent circuits. The product is a component of the JABLOTRON 100 system, is addressable and occupies one position in the system.

JA-150TP Wireless indoor thermostat

Designed to measure and control the indoor temperature. The thermostat expands the application range of the JABLOTRON 100 system in the domain of home automation with simple zone control.

JA-111TH Bus temperature detector

It supports heating control by means of a control panel programmable output based on the measured temperature. All the functions are set in MyJABLOTRON, allowing the user to monitor and control everything anytime anywhere.