Jablotron

JA-111ST-A Bus combined smoke and heat detector

Used to detect a fire risk in the interior of residential or commercial buildings. It comprises of a siren that indicates a fire alarm, both from the entire detector and from another fire detector in the system.

Bus combined smoke and heat detector

JA-111ST-A Bus combined smoke and heat detector

If the detector’s power is supplied from the control panel bus, it works as a system device (EN 54-7; EN 54-5).

If the detector is supplied by inserted batteries (3x 1.5 V AA), in the case of a loss of the 12V supply voltage or communication with the control panel, it continues working as an autonomous unit (EN 14604).

The detector indicates a dangerous situation optically with an integrated light and with a siren. It is able to acoustically report:

  • a fire alarm detected by the detector itself
  • a fire alarm from the system (alarm triggered by another fire detector)
  • another type of alarm (e.g. an intruder alarm)
  • for alarms reported by the system, sections can be set for which the alarm will be indicated

The product contains two separate detectors – an optical smoke detector and a temperature detector. The optical smoke detector uses the diffused light principle. It is very sensitive to particles that are present in thick smoke. It is less sensitive to small particles produced by the burning of liquids such as e.g. alcohol. Therefore, a heat detector is integrated, which responds better to a fire developing heat quickly with a small amount of smoke.

The fire detectors should be installed by a trained installer with a valid Jablotron certificate. The detector is not designed for installation in industrial environments.

Technical specifications

Power 9 – 15 V DC/ 3.5 mA (150 mA during an alarm)
3x alkaline batteries AA 1.5 V / 2.4 Ah
3x lithium batteries FR6 (AA) 1.5 V / 3.0 Ah
Please note: Batteries are not included
Typical lifetime approx. 3 years
Smoke detection optical light scattering
Smoke detector sensitivity m = 0,11 - 0,13 dB / m
pursuant to EN 14604:2005, EN 54-7
Heat detection class A1 according to EN 54-5
Alarm temperature + 60 °C to +65 °C
Operating temperature range -10 °C to +65 °C
Dimensions, weight diameter 126 mm, height 52 mm, 150 g
Conformity EN 50130-4, EN 55022

Related products

LD-81 The LD-81 flood detector

The detector indicates room water floods (e.g. cellars, bathrooms). This information is sent to an alarm system for alert message transmission. It is connectible to an Oasis alarm system via a JA-81M wireless detector.

JA-180G Wireless gas leak detector

The JA-180G detector is used to indicate leaking of explosive gases (natural gas, methan, propane, butane). The detector detects two levels of gas concen-tration - different output reactions.

JA-110ST Bus combined smoke and temperature detector

The JA-110ST bus fire detector (optical and temperature detection) detects fire in residential and commercial buildings . Allows you to set detection: optical and thermal, optical or thermal, optical only or temperature only.

JA-150ST Wireless fire and temperature detector

The JA-150ST optical wireless smoke and temperature detector detects fire inside residential or commercial premises. It allows these settings: smoke and heat, smoke or heat, smoke only, heat only.

JA-110F Bus flood detector

The detector is used to indicate flooding (in basements, bathrooms, etc.). This information is transmitted to the alarm system bus.

JA-110TP Bus indoor thermostat

In a building, up to 4 thermostats can be installed that can control up to 4 independent circuits. The product is a component of the JABLOTRON 100 system, is addressable and occupies one position in the system.

JA-150TP Wireless indoor thermostat

Designed to measure and control the indoor temperature. The thermostat expands the application range of the JABLOTRON 100 system in the domain of home automation with simple zone control.

JA-111TH Bus temperature detector

It supports heating control by means of a control panel programmable output based on the measured temperature. All the functions are set in MyJABLOTRON, allowing the user to monitor and control everything anytime anywhere.