The JA-80Z signal repeater can extend the range of remote devices whose signal is not strong enough to communicate with the control panel or whose communication is unreliable. .
The repeater function lies in the retransmission of a signal received from an enrolled device with a little delay. The delay ensures that a possible conflict between the repeater transmission and the transmitting device is avoided. Each device enrolled to the repeater must concurrently be enrolled to the control panel
A double-balanced INP input with a selectable natural reaction (default: delayed loop) is available for the connection of one hard-wire detector. Activation of this input is transmitted to the control panel as a signal from a device to which the repeater has been enrolled in the control panel. The reaction of this loop can be configured in the control panel.
The repeater front cover is protected with a built-in tamper sensor and the box must be protected against being torn off the wall with a tamper device delivered with the package.
The repeater must be equipped with a backup battery (e.g. SA-214/1,3) which ensures its operation when there is a power supply failure
|Power source||230 V / 50 Hz, max 0.1 A, protection class II|
|Power supply||type A (EN 50131-6)|
|Backup battery||12 V, 2.2 Ah|
|Backup power output||maximum continuous load 0.7 A|
|Number of wireless device addresses||40|
|Hard-wired inputs||1x double balanced input (one input reserved for the rear tamper contact)|
|EW external warning output||switching to GND, max. 0.5A|
|IW internal warning output||switching to GND, max. 0.5A|
|PGX, PGY outputs||max. 0.1 A, switching to GND|
|Frequency (JA-82R)||868 MHz|
|Security grade||2 (according to EN50131-1, EN 50131-6 and EN 50131-5-3)|
|Environmental class||II. indoor-general (-10 to +40°C) compliant with EN 50131-1|
|Radio emissions||ETSI EN 300220|
|EMC||EN 50130-4, EN 55022|
|Can be operated according to||ERC REC 70-03|