Jablotron

JA-180N Wireless relay output module

The module contains two radio controlled power relays . It is mains-powered and can be used for the wireless remote control of devices using JA 18xJ devices and can receive signals from wireless JA-18x devices.

Wireless relay output module

JA-180N Wireless relay output module

 

















Specifications

Power supply230V/50Hz, protection class II
Power consumption1W
Relay contact rating:resistive load up to 2.5 A / 250V AC
inductive (capacitive), load up to 0.5 A / 250V AC
Fuse5A
Communication band868.1 MHz, JABLOTRON protocol
Device enrollmentNon-volatile memory (not erased with the power off)
Minimum distance to transmitters1m
Dimensions, weight:76 x 110 x 33 mm, antenna 35 mm, 120 g
Operational environmentindoor general -10 to +40 ° C
Housing gradeIP40 according to EN 60529
Mechanical resistanceIK08 according to EN 50102
MeetsETSI EN 300 220, EN 50130-4, EN 55022 and EN 60950-1

Related products

JA-110N Bus power output module PG

The JA-110N power output module PG offers a switching relay (16 A) with NO or NC modes . The corresponding PG output copied is set by DIP switch (one of the PG outputs PG 1 - 32).

JA-111N Bus signal output module PG

The JA-111N power output module PG offers a switching relay (2 A/60V DC) with NO or NC modes . The corresponding PG output copied is set by DIP switch (one of the PG outputs PG 1 - 32).

JA-150N Wireless power output module PG

The JA-150N is a wireless PG power output module (10 A/230 V AC). It copies the state of a selected PG output in the JA-100 system (PG1 to PG 32).

JA-151N Wireless signal output module PG

The JA-151N is wireless PG power output module (1 A/24 V DC). It copies the state of a selected PG output in the JABLOTRON 100 system (PG 1 to PG 32).

JA-118N Eight-channel bus output module

The JA-118N eight-channel output module provides outputs for signaling the status of 8 sections, signaling IW / EW alarms in the 8 sections or the status of 8 PG outputs.

JA-110N-DIN Bus DIN power output module

The JA-110N-PG-DIN module is designed for a DIN rail. Provides a power relay output. It can be used, for example, to control lighting, fans, etc. The relay output is programmable by control panel.

JA-120N Bus module for control of an electric lock

The JA-120N module is designed for the power supply and control of electric locks and release systems from the system bus. It is fitted with batteries that ensure the initial current impulse required to open el. locks.

AC-160-DIN Wireless multifunctional relay for DIN-rail installation

The wireless multifunctional relay is a component of the JABLOTRON 100 system, but it can be equally installed as a stand-alone device without a link to a control panel.