Jablotron

JA-185ST Wireless combined smoke and heat detector

The JA-185ST is used to detect fire hazards in the interior of residential or commercial buildings. The detector can be installed also in mobile homes or caravans. It is not designed to be installed in industrial premises.

Wireless combined smoke and heat detector

JA-185ST Wireless combined smoke and heat detector

The JA-185ST detector uses wireless communication and it is powered with three AA batteries.

The detector indicates a fire hazard using the built-in LED indicator and acoustic signalling.

The JA-185ST consists of two independent detectors – an optical smoke detector and a heat detector. The optical smoke detector works on the principle of scattered light. It is very sensitive to large dust particles which are present in dense smoke. It is less sensitive to smaller particles generated by the combustion of liquids such as alcohol. That is why the fire detector also contains a built-in heat detector which has a slower reaction but is much better at detecting fire which generates only a small amount of smoke.

Specifications

Power 3 x AA alkaline batteries 1.5 V, 2.4 Ah
Please note: Batteries are not included
Typical lifetime approximetly 3 years
Communication band 868.1 MHz, Oasis protocol
Communication range approximetly 300 meters (unrestricted area)
Dimensions diameter 126 mm, height 50 mm
Smoke detection optical light scattering and acoustic signalling
Sensitivity of smoke detector m = 0.11 - 0.13 dB/m Pursuant to EN 14604:2005, EN 54-7
Temperature detection class A1 according to EN 54-5
Alarm Temperature +60 ° C to +65 ° C
Operating temperature range -10 ° C to +65 ° C
Meets EN 54-25, EN 54-7, EN 54-25
Complies with ETSI EN 300 220, EN 50130-4, EN 55022, EN 60950-1
Can be operated to ERC REC 70-03

Related products

LD-81 The LD-81 flood detector

The detector indicates room water floods (e.g. cellars, bathrooms). This information is sent to an alarm system for alert message transmission. It is connectible to an Oasis alarm system via a JA-81M wireless detector.

JA-180G Wireless gas leak detector

The JA-180G detector is used to indicate leaking of explosive gases (natural gas, methan, propane, butane). The detector detects two levels of gas concen-tration - different output reactions.

JA-110ST Bus combined smoke and temperature detector

The JA-110ST bus fire detector (optical and temperature detection) detects fire in residential and commercial buildings . Allows you to set detection: optical and thermal, optical or thermal, optical only or temperature only.

JA-150ST Wireless fire and temperature detector

The JA-150ST optical wireless smoke and temperature detector detects fire inside residential or commercial premises. It allows these settings: smoke and heat, smoke or heat, smoke only, heat only.

JA-110F Bus flood detector

The detector is used to indicate flooding (in basements, bathrooms, etc.). This information is transmitted to the alarm system bus.

JA-110TP Bus indoor thermostat

In a building, up to 4 thermostats can be installed that can control up to 4 independent circuits. The product is a component of the JABLOTRON 100 system, is addressable and occupies one position in the system.

JA-150TP Wireless indoor thermostat

Designed to measure and control the indoor temperature. The thermostat expands the application range of the JABLOTRON 100 system in the domain of home automation with simple zone control.

JA-111TH Bus temperature detector

It supports heating control by means of a control panel programmable output based on the measured temperature. All the functions are set in MyJABLOTRON, allowing the user to monitor and control everything anytime anywhere.